







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Vanities, Tile & Fixtures in Irvine: What the Job Actually Costs
Vanities, tile and fixtures in Irvine typically run $9,000 to $28,000 when you’re replacing the vanity, re-tiling the floor and shower walls, and swapping out the faucet, shower trim and lighting in one pass. A single-bath job with a modest vanity and ceramic floor tile can land near the low end. Two baths, porcelain slab or glass mosaic, and a relocated vanity from 36 to 60 inches push you toward the top. Call (833) 749-3967 for a written, line-item estimate.
How We Run a Vanities, Tile & Fixtures Job in Irvine

Most single-bathroom fixture and tile packages take four to six working days once materials are on site. Here’s the real sequence, stage by stage.
Day 1: Demo and protection
We cover the tub or shower pan, mask the doorways and pull the old vanity, faucet, mirror and any tile that’s coming out. Floor tile gets chipped down to the substrate; we check for soft drywall around the shower and any water staining under the toilet flange. You decide then whether a soft spot is a patch or a full wall replacement; we don’t guess.
Day 2: Rough-in and substrate
If the vanity is moving or growing, this is when the drain and supply lines relocate and the new GFCI outlet goes in. Tile substrate goes up: cement board or a bonded waterproofing membrane behind the wet areas, a self-leveler or backer on the floor if the old framing is out of plane. You’ve already picked the tile and grout by now, because this is the irreversible stage.
Day 3: Waterproofing and inspection
Wet-area waterproofing goes on and we photograph it before anything gets covered. If the work touches plumbing, electrical or wall layout, the Irvine inspection happens before tile goes over it. That photo set is yours to keep.
Days 4 – 5: Tile setting, vanity install, fixtures
Floor tile lays first so it cures underfoot. Wall tile and any mosaic band follow. The vanity sets level and gets shimmed to the floor, not just screwed to the wall, so the doors don’t rack in a year. Faucet, drain, shower valve trim, toilet and lighting trim finish the stage. You choose grout color and sealant type at the start of day 4, not the end.
Day 6: Grout, silicone, punch list
Grout cures, silicone seals the wet corners, and we walk the room with you. Anything that reads wrong gets fixed before we invoice. Every job carries our 730-Day Done Right Promise – if it’s not done right, we make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Vanity, Tile and Fixture Choices That Actually Matter
Every one of these is a real fork in the road, and each one moves the price and the lifespan of the room.
- Vanity cabinet material: plywood box with a solid-wood face holds up to Irvine’s dry summer air far better than particleboard, which swells at the first slow leak under the sink. Expect a $300 to $900 gap between the two at the same size.
- Vanity top: quartz and Cambria hold up to daily use and never need sealing; marble is beautiful and stains if you leave a lemon on it; cultured marble is the budget pick and yellows over time.
- Floor tile: porcelain is the workhorse – dense, waterproof, and it handles the dry season without cracking. Natural stone (travertine, slate) needs sealing every 12 to 18 months and costs more to install correctly because the edges and grout lines demand more attention.
- Shower wall tile: large-format porcelain slab cuts the grout lines and cleans in seconds; glass mosaic is the classic look but every tiny joint is a place for soap scum and hard water to settle.
- Fixtures: Kohler and Moen trim hold up; the cheap big-box valve cartridges are the ones that start dripping in year three. We’ll spec a brand you can still get parts for in a decade.
- Mirror and lighting: a framed or LED-backlit mirror needs its own circuit; a surface-mount fixture doesn’t. That’s an electrical scope decision, so it’s decided early.
- Window and glass: if the bathroom window gets replaced in the same pass, we often pair it with Therma-Tru or ECO Window Systems units so the frame and trim match the new tile.
What Vanities, Tile & Fixtures Cost in Irvine, CA?

A full package in Irvine runs $9,000 to $28,000. Here’s how the line items break down.
| Line item | Typical range |
|---|---|
| Vanity installation (cabinet + top + sink) | $800 – $3,000 |
| Floor tile (demo, substrate, set) | $2,000 – $6,500 |
| Shower wall tile and waterproofing | $2,500 – $7,500 |
| Fixture package (faucet, shower trim, toilet, lighting) | $1,200 – $4,000 |
| Rough-in plumbing or electrical relocation | $800 – $3,500 |
| Permit and inspection | $350 – $1,200 |
What pushes the job to the low end vs the high end
- Number of bathrooms: one bath sits near $9,000; two baths almost double the tile and fixture scope.
- Vanity size and move: same-footprint swap is cheap. Going from a 36-inch single to a 60-inch double means moving the drain and adding a supply line.
- Tile choice: ceramic floor plus a 3×6 subway wall is the budget lane; porcelain slab or glass mosaic adds material and labor.
- Existing condition: soft drywall, a cracked pan, or out-of-plane framing adds prep days.
- Permit scope: a like-for-like vanity swap is often exempt; moving plumbing, electrical or a wall is not.
Every written estimate lists material allowances, labor, permit and disposal separately. The number you see is the number you pay. What isn’t included: structural repairs found behind the wall after demo, and homeowner-supplied tile that arrives short or broken. We price those in writing before we proceed, not after. Call (833) 749-3967 for an exact quote – estimates are free.
See the difference
Before
After
Before
After
Before
AfterWhat Irvine Homes Specifically Do to This Job
Irvine is a master-planned city built almost entirely by the Irvine Company from the 1970s onward, and that changes how a vanity-and-tile job runs here. In Woodbridge or Northwood, the original tract vanities from the late 1970s and 1980s are usually the failure point – particleboard boxes swollen under the sink, laminate tops lifting at the backsplash seam, and a shower pan that’s outlived its liner. We see the same floor plan whether we’re in Turtle Rock or a newer Great Park build, because the villages were built to repeat.
The bigger Irvine-specific reality is approval. Most of the villages sit under Irvine Company HOAs with architectural review committees, and the city runs its own design-review process on top of that. That means fixture finish, exterior-visible glass and any window trim are reviewed against a palette before we install. A job that would be a straight swap in Santa Ana can wait on a committee sign-off here. Permits are pulled through the city, and plumbing or electrical relocation triggers its own inspection – which we schedule before tile goes over it. In the Great Park and former El Toro base area, grading and environmental layers add review time on any new construction or addition. The upside of the dry climate: no freeze or rain delays, and a long warm season that’s kind to grout cure. Call (833) 749-3967 to start the paperwork question early.
Serving Irvine, CA – Our Local Coverage Area
We serve Irvine and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Vanities, Tile & Fixtures in Irvine

Plan on four to six working days for a single bathroom once materials are on site, and seven to ten for two baths. Add one to three weeks ahead of that if your village HOA requires architectural review and material sign-off. Schedule is confirmed in the written estimate.
Not always. A like-for-like vanity swap and re-tiling over the same substrate usually don’t require a permit. Moving plumbing, adding electrical, or changing a wall layout does, and Irvine inspects the rough-in before tile covers it. We tell you in writing which side of that line your job sits on.
Yes, and most jobs stay that way. A same-footprint vanity, new tile over the existing layout, and new fixtures are a straightforward swap. The moment the vanity width or location changes, that’s a rough-in stage – and it’s a decision we make before day 1, not mid-job.
Workmanship is covered by our 730-Day Done Right Promise. Manufacturer warranties on the vanity cabinet, faucet and tile run alongside that on their own terms. If something we installed isn’t right, we come back and we make it right.
No – the written estimate is the price. The only exceptions are conditions found behind the wall after demo, like soft framing or a cracked shower pan liner. Those get a written approval from you before we touch them. Call (833) 749-3967 for a free quote.
Schedule a Free Estimate for Vanities, Tile & Fixtures in Irvine
Call (833) 749-3967 to book a free on-site estimate for vanities, tile and fixtures in Irvine. A live person answers, 24 hours a day. We’ll bring samples, measure the room, check the plumbing and electrical, and walk you through the written, line-item price with material allowances spelled out. If the job is part of a wider Bathroom Remodeling in Irvine, we scope the two together. If the same visit turns up a roof problem, homeowners often pair this with Tile Roofing in Irvine. Ask about 0% financing for 18 months and $1,000 off projects over $10,000. See our full Bathroom Remodeling service and how we cover Irvine. Homeowners often pair this with Specialty Roofing in Irvine.
Written by the team at Groundwork Construction Co.












