







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Vanities, Tile & Fixtures in Santa Ana: What the Job Actually Costs and Covers
Replacing a vanity, retiling a bathroom floor or shower surround, and swapping out fixtures in Santa Ana typically runs $9,000 – $28,000 for a full bathroom’s worth of work, or as little as $800 – $3,000 if you’re only changing the vanity. Most of these jobs take 5 – 10 working days once materials are on site. Tile selection and fixture lead times are what stretch a schedule, not the labor. Call (833) 749-3967 for a free on-site estimate with a written line-item quote.
How We Run a Vanities, Tile & Fixtures Job, Stage by Stage

Small jobs go sideways when nobody sequences them. Here’s the order we work in, and what you decide at each point.
Stage 1: Measure, template, and lock the spec (day 1, 2 – 3 hours). We measure the vanity opening, check the drain and supply locations, and confirm whether the existing valve bodies are worth keeping. You decide the vanity width and depth, the countertop material, and whether the new faucet needs a relocated supply. On Santa Ana bungalows this is also where we find out if the wall behind the old vanity is drywall over lath or straight plaster, which changes the prep.
Stage 2: Demo and rough-in inspection (days 2 – 3). Old vanity, toilet, tile, and backer come out. We open the wall only where we need to. If we’re moving the drain or adding a GFCI receptacle behind the vanity, the rough plumbing and electrical get inspected before anything closes back up. You decide at this point whether to add a niche or a bench in the shower, because after waterproofing it’s expensive to change your mind.
Stage 3: Waterproofing and substrate (day 3 – 4). Cement board or a bonded waterproof membrane goes up, seams get taped and coated, and the pan gets built or set. This stage is invisible when it’s done and it’s the reason a tile job lasts 30 years instead of 6. We don’t skip the flood test on a new shower pan.
Stage 4: Tile setting and grout (days 4 – 8). Wall tile first, then floor, then grout and seal. Large-format porcelain goes up faster than 3-inch hex; a herringbone pattern on a small floor adds a day of layout and cutting. You decide grout color and whether you want epoxy grout, which costs more and resists staining far better in a busy bathroom.
Stage 5: Vanity set, fixtures trim-out, and final walk (days 8 – 10). Vanity gets leveled and anchored to studs, countertop set, faucet and drain connected, toilet reset, mirror and accessories hung, silicone run at every wet seam. Then we walk it together and you get the 730-Day Done Right Promise in writing. If a supply line weeps or a tile pops, we come back.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices That Actually Matter on This Job
Most of the money in a vanities, tile and fixtures job sits in four decisions. Here’s the honest trade-off on each.
- Vanity construction: a stock big-box vanity ($800 – $1,500 installed) is plywood or particleboard with a glued-on top and will hold up fine in a guest bath. A semi-custom cabinet like KraftMaid ($1,500 – $3,000) buys you a real wood box, dovetail drawers, and a size that actually fits the wall. In a hall bath used by kids, we lean stock. In a primary bath, semi-custom pays for itself at resale.
- Countertop: quartz and engineered stone ($400 – $900 for a typical 48-inch top) resist water and stains and need no sealing. Natural marble looks better and etches if you leave a lemon on it. Laminate is the cheap route and shows its age fastest in a wet room.
- Tile material: porcelain ($4 – $12 per square foot installed) is dense, frost-proof, and forgiving in a bathroom. Ceramic is cheaper and softer. Natural stone like travertine ($12 – $25 installed) needs sealing every year or two and is heavier on the wall.
- Fixtures: a mid-grade branded faucet holds a finish for a decade; the $49 special starts pitting in two years. Kohler and Moen are the two we recommend most often for the trim-out because parts are stocked locally if something fails. A pressure-balance shower valve is worth the extra $150 over a two-handle valve and is what most buyers expect now.
What Vanities, Tile & Fixtures Costs in Santa Ana, CA

A standard full-bath refresh with a new vanity, tile floor, and new fixtures in Santa Ana runs $9,000 – $28,000. A vanity-only swap is $800 – $3,000. The five variables that push you to the high end:
- Size and tile area. Wall tile floor to ceiling is roughly double the square footage of a standard surround and doubles the tile line item.
- Existing condition. Water damage behind a 1950s vanity, rotted subfloor, or a failed pan turns a $9,000 job into $18,000 fast.
- Relocating plumbing or electrical. Moving a drain or adding a GFCI circuit means permits and inspection. Keeping the fixtures where they are saves real money and often weeks.
- Material grade. Porcelain vs. stone, epoxy vs. cement grout, stock vs. semi-custom vanity. A high-grade spec is most of the gap between a $12,000 job and a $24,000 one.
- Permit scope. A cosmetic swap (vanity, fixtures, no wall opening) usually needs no permit. Tile over existing backer or moving a drain does.
Every written estimate lists each line item, the material grade, and the labor separately. Any add-on we uncover mid-job (a rotted stud, a leaking valve) gets priced in writing before we touch it. Call (833) 749-3967 for an exact quote at the free on-site estimate.
See the difference
Before
After
Before
After
Before
AfterWhat Santa Ana Homes Specifically Do to This Job
Santa Ana’s housing stock is why a “simple” vanities and tile refresh here is never truly simple. Much of the city’s housing is 1920s – 1950s California bungalows and Spanish Colonial Revival homes, and in the pre-1940 downtown and Lacy-area bungalows original redwood framing and clay sewer laterals are common, so a wall we open for a vanity can require a city historic-preservation review if we’re touching structure. In the ZIP 92705 blocks off the eastern hill edges we see original knob-and-tube wiring behind bathroom outlets; we recommend tracing any old circuit before a new vanity light goes in. Postwar stucco tract housing in the western flat sections tends to have more recent re-pipes and is generally a straightforward tile and fixture job. Across all of it, the dry Santa Ana winds age exterior trim and the winter rains expose slow leaks behind shower surrounds. We cover the full city, so if you’re in ZIP 92702, 92712, or 92725, we can schedule an estimate in Santa Ana as part of a Bathroom Remodeling in Santa Ana scope or on its own as a vanity and tile project through our Bathroom Remodeling service.
Serving Santa Ana, CA – Our Local Coverage Area
We serve Santa Ana and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Vanities, Tile & Fixtures in Santa Ana

Plan 5 – 10 working days once materials are on site, plus 2 – 4 weeks of lead time for tile and specialty fixtures. A vanity-only swap is often a one-day job. Custom tile layouts and niche work add days. Call (833) 749-3967 to get a firm schedule from the on-site walk.
A cosmetic refresh (new vanity, new faucet, tile on existing backer) usually needs no permit; moving a drain, adding an electrical circuit, or opening structure typically does. We tell you which applies before we write the estimate, and we pull the permit where required so the inspection passes. Call (833) 749-3967 and we’ll walk you through your scope.
Yes, and it’s the most common version of this job. As long as the drain and supply lines are in good shape, a new vanity and trim-out can go in without opening the wall. Call (833) 749-3967 and we’ll confirm whether the existing valve bodies are reusable at the estimate.
Full-bath scope runs $9,000 – $28,000; vanity-only is $800 – $3,000; and a shower tile and trim-out job typically lands in the middle. Grade of tile, vanity construction, and whether plumbing moves are the main drivers. Call (833) 749-3967 for a line-item free estimate.
Every install is covered by the 730-Day Done Right Promise, and most jobs finish in a single visit once materials are on site. If a connection leaks or a tile fails, we come back. Homeowners in Santa Ana often pair this bathroom work with Tile Roofing in Santa Ana or Specialty Roofing in Santa Ana on the same visit.
Free On-Site Estimate for Vanities, Tile & Fixtures in Santa Ana
Call (833) 749-3967 to book a free estimate in Santa Ana. We’ll measure the vanity, check the tile substrate and fixtures, and hand you a written line-item quote with grades and labor split out, plus the options for a stock vs. semi-custom vanity and porcelain vs. stone. Our technicians have up to 12 years of experience, arrive background-checked and in uniform, and all work is covered by the 730-Day Done Right Promise.
Written by the team at Groundwork Construction Co.












