







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tile Roofing in Dana Point, CA: What It Takes and What It Costs
Tile roofing in Dana Point usually means a tile repair or partial re-roof running $600 – $2,500, and a full tile roof replacement running $8,000 – $20,000 depending on roof size, tile type, and how much underlayment and flashing has to be rebuilt. Most repair jobs finish in one to two days. A full replacement typically takes four to seven working days. Call (833) 749-3967 and we’ll give you a written, line-item number before anything gets torn off.
How a tile roof job actually runs, stage by stage

Tile isn’t shingle. You can’t staple new material over old and call it done. The tile is the visible skin; the underlayment and flashing underneath are what actually keep Dana Point’s marine-layer moisture out of your house. Here’s the sequence we follow.
Stage 1: Inspection and moisture mapping (half a day)
We walk the roof, photograph cracked and slipped tiles, feel the underlayment for brittleness, and check the flashings at valleys, chimneys, and vents. On older Capistrano Beach homes we often find the original felt has dried out and cracked under perfectly good-looking tile. You decide at this point whether you’re repairing or replacing, and we give you both numbers in writing so the choice is yours, not ours.
Stage 2: Tile removal and deck inspection (one to two days)
Tile comes off and gets sorted: reusable field tile to one pile, broken tile to the dumpster. Once the deck is bare, we check the sheathing for rot, soft spots, and delamination. This is the stage where budgets move, and we don’t hide it. You get photos and a written change order before any deck repair begins.
Stage 3: Underlayment and flashing (one to two days)
New underlayment goes down, then the flashings get set at every penetration and transition. On the salt-exposed lots near the harbor, we spec corrosion-resistant fasteners and flashing because standard galvanized hardware pits within a few seasons in the onshore air. You decide the underlayment grade here; it’s the single biggest driver of how long your roof lasts.
Stage 4: Tile setting and dry-in (one to two days)
Tiles get laid, cut at hips and valleys, and mechanically fastened per the manufacturer’s wind rating. We check alignment and coursing as we go, not after. If you want a specific tile profile or color, this is the day it has to be on site.
Stage 5: Final inspection and walkthrough (half a day)
We clean the gutters, sweep the yard with a magnet for fasteners, and walk the roof with you or send you a photo report. We also confirm the permit inspection is scheduled or passed. That’s the whole job, and every stage has a decision point you’re part of.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The tile and underlayment choices you’ll actually weigh
Most of the decision-making on a Dana Point tile roof comes down to tile material, underlayment type, and how the roof handles wind and salt. Here’s the honest trade-off on each:
- Clay barrel tile: The premium look and the longest service life, and heavy enough to handle coastal wind uplift well. It costs more per square and requires a structure that can carry the weight. Best for homeowners staying put long-term.
- Concrete tile: Similar profile and lifespan to clay at a lower price, with a broader color range. Slightly more porous than clay, so underlayment quality matters even more.
- Flat or low-profile tile: Popular on the mid-century ranch homes in the Lantern District. Lighter and less expensive, but it sheds debris less efficiently, so your gutters need attention.
- Underlayment grade: The layer nobody sees and everyone should care about. A standard felt is fine for inland climates; a high-temp synthetic membrane holds up much longer under tile that bakes in the sun and soaks in the marine layer.
- Flashing and fastener spec: Non-negotiable on the coast. Corrosion-resistant flashing and fasteners cost a bit more up front and save you a re-roof a decade early.
If your roof project is part of a larger exterior refresh, homeowners often pair tile work with Energy-Efficient Windows in Dana Point so the envelope gets handled once instead of twice.
What Tile Roofing costs in Dana Point, CA

Tile roof repair in Dana Point runs $600 – $2,500. A full tile roof replacement runs $8,000 – $20,000. Those are real market numbers, not teasers. Here’s what moves a job toward the low or high end:
- Roof size and pitch: A steep canyon-lot roof takes more labor and more safety setup than a flat ranch roof.
- Deck condition: Rotted sheathing on a 1970s wood-frame home adds deck replacement to the bill.
- Tile material: Clay barrel sits at the top of the range; concrete and flat tile sit lower.
- Underlayment and flashing grade: Upgraded synthetic membrane and corrosion-resistant flashing push the number up, and are worth it here.
- Permit and inspection scope: A full re-roof needs a permit; a small repair usually doesn’t.
Your written estimate breaks out tear-off, deck repair, underlayment, flashing, tile, and permit fees as separate lines. The number you see is the number you pay, backed by our 730-Day Done Right Promise. Larger projects qualify for 0% financing for 18 months and $1,000 off projects over $10,000.
See the difference
Before
After
Before
After
Before
AfterWhat Dana Point homes specifically do to this job
Dana Point’s coastal bluff and canyon topography is the thing that shapes a tile roof job here more than anything else. Much of the buildable land sits on coastal terraces and steep canyon slopes above the harbor, which means roofs sit in salt-laden onshore air and take winter storm surf wind head-on. That combination corrodes fasteners and flashing faster than inland, and it’s why we spec corrosion-resistant hardware on nearly every roof in 92629. The housing stock swings widely: 1960s-70s single-story ranch homes and beach cottages in Capistrano Beach and the Lantern District on one side, newer custom homes on the bluff lots on the other. On the older homes, we routinely find original underlayment baked brittle under tile that still looks fine, and on canyon lots off Del Obispo and Selva, undersized original drainage means winter rain gets pushed against downhill retaining walls and finds its way under flashing. Coastal development review applies to structural changes, so if your tile work is part of a larger project, our Roofing in Dana Point page walks through the full scope. And when a tile roof meets a wind-driven storm, pairing it with Impact Windows & Doors in Dana Point closes the gaps that let pressure build under the roof edge.
Serving Dana Point, CA – Our Local Coverage Area
We serve Dana Point and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Tile Roofing in Dana Point

A full tile roof replacement typically takes four to seven working days, weather permitting, and a tile repair usually finishes in one to two days. Coastal fog can add a day to the underlayment stage. Call (833) 749-3967 for a timeline on your specific roof.
A full tile roof replacement and any structural work need a permit and inspection; a like-for-like tile repair typically doesn’t. We pull the permit and coordinate the inspection as part of the job, so you’re not chasing the city. Call us for a straight answer on your scope.
No, and you shouldn’t want it. The underlayment and flashing underneath are what fail first, and they can only be replaced with the tile off. A layover hides the real problem and voids most tile warranties. Call (833) 749-3967 for a written estimate that shows the tear-off cost up front.
Tile roof repair in Dana Point runs $600 – $2,500, depending on how many tiles are broken, whether flashing needs replacing, and how accessible the roof is. We give you a fixed written quote before we start. Estimates are free.
Our workmanship is covered by the 730-Day Done Right Promise – if it’s not done right, we make it right – and manufacturer warranties on the tile and underlayment apply on top of that. We hand you the paperwork at the walkthrough. Call (833) 749-3967 to schedule your free estimate.
Get a written estimate for your tile roof
We’ll come out, inspect the roof, photograph what we find, and hand you a line-item estimate covering tear-off, deck repair, underlayment, flashing, tile, and permit. No pressure, no vague bids. Our technicians have up to 12 years of experience and every job is backed by the 730-Day Done Right Promise. We cover Dana Point and the surrounding coast, and you can see our full Roofing service for the wider scope. Call (833) 749-3967 – a live person answers, day or night.
Written by the team at Groundwork Construction Co.












