







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in North Tustin, CA: What It Costs and What to Expect
A chain link fence for a typical North Tustin lot runs $3,500 to $9,000, with most jobs finishing in two to three days once the layout is set and the county has signed off where a permit is required. Galvanized steel is the standard choice for property lines, dog runs, and pool enclosures; vinyl-coated and black-coated chain link dress up the front of the house and cost more. Call (833) 749-3967 for a free on-site estimate.
How a Chain Link Fence Goes In, Stage by Stage

Chain link is a fast, predictable build compared with most exterior work, but the sequence matters. Here’s how we run a residential chain link job in North Tustin from first visit to final tension.
Day 1, morning: layout and utility locate
We walk the property line with you and mark posts every 8 to 10 feet, confirming corners, gates, and any grade changes before a shovel hits dirt. We call 811 for the free utility locate and clear the alignment so nothing gets cut. If the fence sits near a shared boundary, this is also when you confirm the setback with neighbors. This stage takes a few hours and the main decision is exact post placement and gate position.
Day 1, afternoon: demo and grading
If there’s an old fence, we remove it, pull the footings, and haul it off. On sloped lots we step the fence line in sections so the top rail follows the terrain instead of leaving gaps underneath. You decide at this point whether you want a stepped look or a smooth racked line. Demo and prep usually take half a day on a standard lot.
Day 2: post setting
We dig post holes to depth and set terminal posts in concrete. Line posts go in on the same run, with the concrete left to cure overnight. This is the step that holds the whole fence together, so it isn’t rushed. The homeowner decision here is minimal; just confirm the gate posts are where you want them.
Day 2 to 3: framing, mesh, and gates
Once the concrete sets, we install top rail, tension wire or bottom rail, and stretch the mesh tight. Gates get their frames, hinges, and latches. The fence should come out plumb, taut, and clean at the corners. Expect roughly half a day for a standard run.
Final walkthrough
We walk the fence with you, check every gate swing and latch, tighten any tension issues, and clean up the site. That’s the job. If anything’s off, the 730-Day Done Right Promise covers it.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Chain Link Options You’ll Actually Choose Between
- Galvanized steel (standard): Bare silver chain link. Cheapest per linear foot and fine for side and back property lines. Holds up in Southern California sun with minimal care.
- Vinyl-coated chain link: Color bonded to the wire in black, green, or brown. Looks cleaner against landscaping and hides rust at cut ends. Costs more per foot but holds color for years.
- Gauge and height: Standard residential is 11.5-gauge wire at 4 or 5 feet. Heavier 9-gauge wire and 6-foot heights suit pool enclosures, dog containment, and privacy goals. Taller, heavier fences cost more.
- Gate style: Walk gates, double drive gates, or self-closing pool gates. Pool gates need a specific latch and swing per California code, so plan for that in the layout.
- Top rail vs. tension wire: A top rail gives a crisper line and better structure. Tension wire alone is a cheaper look for back-of-lot runs.
- Post and terminal type: Standard posts, or heavier posts at corners and gate openings. Good corner posts prevent sag later.
What Chain Link Fence Costs in North Tustin, CA

Most North Tustin chain link projects land between $3,500 and $9,000. Here’s how the number breaks down:
| Scope | Typical Range |
|---|---|
| Basic galvanized property-line fence, standard lot | $3,500 – $6,000 |
| Vinyl-coated or black chain link, visible areas | $5,500 – $8,000 |
| 6-foot pool enclosure with code-compliant gate | $6,000 – $9,000 |
| Old fence removal and haul-off | $400 – $1,200 |
The main variables that push a job to the high end: linear footage and number of corners, whether old footings need to be dug out, slope on hillside lots, heavier gauge or taller height, and gate additions. A written estimate includes materials, labor, concrete, demo, and haul-off. What it typically doesn’t include: tree or brush clearing, replacing damaged sprinkler lines, or county permit fees if a permit is required. Call (833) 749-3967 for an exact quote; estimates are free.
See the difference
Before
After
Before
After
Before
AfterWhat North Tustin Homes Specifically Do to This Job
North Tustin is unincorporated Orange County, so fence work here runs through county review rather than a city hall. That matters on properties with recorded easements or hillside slope beyond a certain grade. On streets off Newport Avenue and in Cowan Heights, we often find an old chain link built over unpermitted footing or partially onto a neighbor’s side, and the correction has to be part of the job. The 1950s – 1970s ranch and custom homes on generous lots also mean fences stretch long runs over varied grade, which drives post spacing and stepping decisions. Brush clearing for defensible space on Santa Ana wind-facing slopes is another common add-on. If you’re planning a wider yard project, homeowners often pair this with a Concrete Driveways & Concrete Work in North Tustin job, and this fence work is usually scheduled as part of Fence Installation in North Tustin plans.
Serving North Tustin, CA – Our Local Coverage Area
We serve North Tustin and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Chain Link Fence in North Tustin

A standard residential chain link fence in North Tustin takes two to three days on-site, plus the 811 locate call and any county permit review. Larger lots with slopes or multiple gates run a day longer. Call (833) 749-3967 to get a firm schedule on your lot.
Fence permits in North Tustin are handled through Orange County because the community is unincorporated, and residential chain link under 6 feet usually doesn’t require one unless it fronts a corner or easement. Heights over 6 feet and pool enclosures are more likely to trigger review. We confirm the requirement during the estimate. Call (833) 749-3967 to check your specific property.
Yes. We do a utility locate and site walk to keep post holes clear of irrigation and landscape features. Some replanting around posts is normal; digging up the whole boundary is not. Call (833) 749-3967 to walk the line with us.
Most chain link fences in North Tustin cost $3,500 – $9,000, depending on footage, height, gauge, coating, and gate count. Pool enclosures sit at the high end because of code-compliant gates and latches. Estimates are free, so call (833) 749-3967 for a written line-item quote.
Our work is covered by the 730-Day Done Right Promise: if it isn’t done right, we make it right. That includes post setting, tension, gate swing, and hardware. Material warranties come from the fencing manufacturer and we hand those to you at completion. Call (833) 749-3967 to schedule your free estimate.
Get a Free Chain Link Fence Estimate in North Tustin
Call (833) 749-3967 to schedule a free on-site estimate for chain link fence work in North Tustin. We’ll measure the run, check the grade, confirm whether the county wants a permit, and hand you a written line-item quote with upfront pricing and no surprises. Calls are answered by a live person, 24/7. We coordinate these projects alongside our Fence Installation service, and often pair them with Asphalt Driveways & Resurfacing in North Tustin when the yard is getting a full refresh. If you want the full scope of what we cover across North Tustin, ask when you call.
Written by the team at Groundwork Construction Co.












