







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Wood Fence in Irvine, CA: Cost, Timeline, and What’s Actually Involved
A wood fence in Irvine typically runs $3,500 to $9,000 installed, with most residential lots landing between $5,200 and $7,400 for a standard 6-foot dog-ear cedar or redwood run. Plan on two to four working days on site once materials are staged, plus the approval time your village HOA adds before anyone digs a hole. Call (833) 749-3967 and we’ll walk your property line, measure the actual run, and give you a written line-item number – the estimate is free and there’s no pressure to sign on the spot.
How a Wood Fence Goes In, Stage by Stage

Five stages, and you make a decision at the end of each one. Here’s the real sequence, not the brochure version.
Stage 1: Site walk and line verification (about an hour)
We measure the run, confirm where the property line actually sits, and check what’s underneath – irrigation lines, low-voltage landscape lighting, gas stubs to a patio grill. In Irvine tract homes this is where we find the shared-block wall situation with a neighbor, which changes who owns which section and sometimes who pays for it. You’ll decide the fence height and whether we’re replacing the whole line or stopping at the corner.
Stage 2: Demo and haul-off (half a day to a full day)
Old panels come out, posts get pulled or cut at grade, and the debris leaves in one load. If the existing fence sits on a shared property line, we coordinate access with your neighbor a few days ahead – Irvine HOAs generally want that coordination documented.
Stage 3: Layout, HOA sign-off, and hole spacing (one to three days, mostly waiting)
Before a single post goes in the ground, we stake the line and hand you the material and color submittal your architectural review committee will want. Woodbridge and Northwood villages both run their own review, and the palette rules are specific – a fence color that’s fine in one village gets bounced in another. This is the stage homeowners underestimate. You’ll pick the stain color and the post cap style here.
Stage 4: Posts, framing, and panels (one to two days)
Posts get set in concrete at the depth the soil calls for, rails get framed, then pickets go up. You’ll decide whether it’s board-on-board or side-by-side and whether you want the “good side” facing you or the neighbor.
Stage 5: Gate hang, stain, and final walk (one day)
Gates get hung and adjusted for swing and latch, stain goes on, and we walk the line with you. Anything that doesn’t sit right gets fixed before we leave the property.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Wood Fence Options You’re Actually Choosing Between
Four real decisions, each with a trade-off worth knowing before you commit.
- Cedar vs. redwood vs. pressure-treated pine. Cedar is the Irvine default – naturally rot-resistant, takes stain well, and handles the dry summer bake without checking as badly as pine. Redwood is the premium pick at roughly 20 to 30 percent more; it looks better longer but you’re paying for appearance, not added life. Pressure-treated pine is the budget route and the one we steer people away from in exposed sun.
- 6-foot vs. 5-foot height. Six feet is standard for privacy and what most Irvine village HOAs will approve. Five feet clears some sight-line rules and can save a few hundred dollars on material, but you lose the privacy most homeowners actually wanted.
- Board-on-board vs. side-by-side. Board-on-board (pickets overlap on alternating sides) blocks sight lines completely and adds wind load resistance – it’s the better build, and it costs roughly 10 to 15 percent more in material and labor. Side-by-side is cheaper and faster but shows gaps as the wood dries.
- Stain finish vs. natural. A penetrating stain applied at install protects against the dry-season cracking we see on unfinished wood here, adds a day to the schedule, and needs a re-coat every few years. Natural-weathering is fine if you like the gray look.
Hardware matters more than most people expect: galvanized or stainless fasteners, and metal post anchors rather than wood posts buried in soil. That last detail separates a fence that stands fifteen years from one that leans in five.
What a Wood Fence Costs in Irvine, CA

Most Irvine wood fence projects land between $3,500 and $9,000, and a typical quarter-acre tract-home property runs $5,200 to $7,400 for a standard 6-foot cedar run. Call (833) 749-3967 for a written line-item quote on your specific run.
Five variables push a job toward the low or high end:
- Linear footage. The single biggest lever. A 60-foot side-yard run sits near the low end; a full perimeter on a larger lot pushes past $8,000.
- Material grade. Cedar to redwood is roughly a 20 to 30 percent jump in material cost alone.
- Existing conditions. Pulling old concrete footings, working around a pool safety barrier, or dealing with root-heavy soil all add labor hours.
- Gates. A standard walk gate is straightforward. A double drive gate with a heavier frame adds labor and hardware cost.
- HOA submittal and city review scope. Review-layer work on a replacement in a master-planned village can add real time and a modest cost to the job.
Your written estimate should state materials, footage, post spacing, hardware, stain, and haul-off as separate lines. What it typically won’t include: HOA application fees, tree removal or trimming in the fence line, or repairing an irrigation system the demo exposed. We flag those on the walk-through rather than springing them later. No-hassle upfront pricing means the number you see is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhat Irvine Homes Specifically Do to This Job
Irvine is a master-planned city, and that fact shows up at the fence line more than almost anywhere else in Orange County. Almost all of the housing stock here was built by the Irvine Company from the 1970s forward – tract villages like Woodbridge, Northwood, and Turtle Rock, plus the newer Great Park-area builds replacing the former El Toro base. That means nearly every wood fence job runs through an architectural review committee and the city’s own design-review process before a post goes in. The color and material palettes are real constraints, and a stain that passes in one village gets rejected in the next.
The failure modes are consistent. Unfinished builder-grade fences inland toward Northwood and the Great Park crack and split from the long dry season – we see it most on west- and south-facing runs that catch the afternoon sun. Cheap builder hardware rusts at the post anchors. And in the higher-density apartment and condo pockets around ZIP codes 92602, 92617, and 92604, shared-line coordination with neighbors comes up on nearly every job.
For a larger outdoor scope, this is often part of a full Fence Installation in Irvine plan, and homeowners often pair this with Paver Driveways in Irvine or Concrete Driveways & Concrete Work in Irvine while the yard is already torn up. We cover Irvine and the surrounding villages through our broader Fence Installation service.
Serving Irvine, CA – Our Local Coverage Area
We serve Irvine and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Wood Fence in Irvine

Two to four working days on site for a standard run, but plan on two to four weeks total once you count HOA review and material lead time. The build itself is fast; the approval layer built into Irvine’s master-planned villages is what sets the real calendar. Call (833) 749-3967 and we’ll give you a realistic date range based on your village.
Fence height and placement rules apply, and most Irvine village HOAs require architectural review before installation. Whether a city permit is also required depends on the height, location, and whether the fence sits on a shared or corner lot. We tell you exactly which approvals your project needs during the free estimate, and we can put those steps in writing. Call (833) 749-3967 to sort it out for your address.
Usually yes. We locate irrigation lines and low-voltage lighting during the site walk and post around them where the spacing allows. When a post lands directly on a line, we reroute it rather than cut it. Call (833) 749-3967 and we’ll flag any conflicts before the estimate so there are no surprise line items.
Most residential wood fence projects in Irvine run $3,500 to $9,000, with a typical quarter-acre lot landing around $5,200 to $7,400. Cedar is the standard; redwood adds roughly 20 to 30 percent, and board-on-board construction adds about 10 to 15 percent. Call (833) 749-3967 for an exact written quote – estimates are free.
Every wood fence we install is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right. That covers workmanship on posts, framing, panels, gates, and stain application for two full years. Call (833) 749-3967 and we’ll put the warranty terms in writing with your estimate.
Get a Free Wood Fence Estimate in Irvine
Call (833) 749-3967 to schedule a free on-site estimate for your wood fence in Irvine. A live person answers around the clock, so you’re never stuck in voicemail. We’ll walk the property line, measure the run, review which approvals your village needs, and hand you a written line-item quote with no-hassle upfront pricing. Technicians are background-checked and arrive in uniform. Most jobs include $1,000 off projects over $10,000, plus 0% financing for 18 months.
Written by the team at Groundwork Construction Co.












